MODIFYING MY E-STIM DEVICE

My E-stim device

 

If you don’t know what an E-stim device is then check out the link for the post that was written on this blog last week.

ELECTRIFYING THE TOY BOX – A REVIEW OF MY E-STIM

 

The problem with the E-stim device

 

 

The thing that I do not like about my E-stim device can be seen in the photograph above. It is that to turn the juice on and off you have to use a dial and then turn up the juice until the required erotic mmmmness or painful ouchyness is achieved. This is annoying and fiddly. It also means  that the sub on the receiving end will feel the build up of the pulse every time that the device is turned on and off.

 

What I wanted from the device

 

 

What I wanted to do is be able to set the E-stim device to the required pulse rate and intensity level desired and then just turn current on for short, two to five second, bursts, without having to fiddle about with the knobs and dials every time.

 

The solution

 

 

Install a simple switch, in the wiring, between the device and the electrical contact pads. The switch above is easily available and cost effective. It is the type of thing that someone might put on the cable of a table lamp, to turn it on and off. This is the switch that I installed in the wiring.

 

How the instillation was done

 

 

This is what the normal set up of the device would look like, ready to punish that bad wallet that lets all my money leak out so quickly.

 

 

First the wire was split at the place where the switch was to be located.

 

 

Then the wire was cut and the ends striped so that they would give a good contact for the connectors in the switch. The switch was opened and disassembled ready to be wired up.

 

 

The wires where then connected up to the main part of the switch. Making sure that the same wires went into and out of the same side of the switch. This was easy to achieve because one of the wires had a thin brown stripe running along it.

 

 

the switch was then reassembled.

 

 

I then tested the new set up with the contact pads on the back of my hand and wrist and found that it worked just as I wanted it to. Now the contact pads can be attached to the desired location, with the required settings and just turned  on and off for short periods of time.

 

Let the torture scene playtime begin

 

An idea for an alternative use for the E-stim

 

 

You will notice, in the photo, that this E-stim device has a belt clip. The device could easily be wired up to a sensitive part of a submissive in a D/d or 24/7 relationship and the wires be hidden under clothing and the E-stim device put on the sub’s belt, the device set to the required pain level and the switch placed in one of the pockets of the sub. Then while the couple are out and about, shopping, at the bank or whatever and the sub commits a minor infringement, that upsets his or her dominant partner, the offended party, instead of waiting until they get home to inflict punishment, can just reach into the pocket of their partner and give them a short, sharp shock (pun intended) there and then.

 

This idea makes me realize that I have a deviant mindset 🙂

 

Prefectdt